None of the adjustment lites were on.
Maytag 5000 series washer door locked.
When reinstalling the door lock replace the electrical shock hazard wire ties through the two standoffs on the disconnect power before servicing.
Pull the door lock mechanism out from behind the door support front plate.
Maytag washer door or lid won t lock.
My maytag series 2000 front loader washer made a loud bang the other night and the machine was unplugged but the door remained locked.
Check your home s fuses circuit breakers.
I removed all the water by opening the cleanout behind the bottom panel but this light still stays on.
It may take up to five minutes for the washer to stop spinning and draining before the door will unlock.
But the door locked lite was on.
Door lock door lock 4.
The machine was moved to put down a new floor.
First check that there is no water left in the machine.
Once the washer door is closed the washer can begin operating.
Maytag 5000 series with steam washer door remains locked.
This is a guide about unlocking the door on a maytag front load washer.
For that new maytag washer that you have you will need to unplug the washer and remove the bottom front service panel as shown in the image below.
If nothing else works the washer door can be opened as follows.
Carefully reach up along the inside of that front panel and pull down on the manual release tab that is on the bottom of the door latch assembly.
My maytag 5000 steamer washer is locked and i cannot open the door.
The washer door will not open.
When we try to turn it off the door stays locked unless we unplug it for a few minutes then plug it back in.
The door lock secures the washer door shut during operation.
At some point i can t remember it was making noise like it was preparing to or was spinning.
The door will not immediately unlock while the cycle is running due to a possible high water level in the washer high water temperature tumbling or spinning.
I put a small load in last nite and went to bed.
My maytag washer goes through it s normal wash cycle but when it is supposed to stop it just keeps going through it s extra spin cycle.
It was off this a m.
I will try and unlock it via the lower panel access.
Check that the main power switch is on.
Clip the two wire ties that secure the wire harness to the door lock assembly.
You will hear the door click when it unlocks.
If the door lock is defective the washer door will not latch properly.
Front loaders have a locking mechanism to avoid opening the door during a washing cycle but occasionally this lock will be activated accidentally.
I pulled the panel at the bottom and was able to open the door but as soon as i close it again it locks and the light stays on.
What code is e2 f3 flashing on machine.
